Wilo-EMU KPR
Axial pump submersible without cooling system for continuous duty in pipe chambers in the stationary wet well installation.
-
Description
Axial pump submersible without cooling system for continuous duty in pipe chambers in the stationary wet well installation.
-
Advantages
- Can be directly installed in the discharge pipe
- Angle of propeller blades is adjustable
- Process reliability thanks to comprehensive monitoring devices
- Low vibration and long service life thanks to high-quality components
- Individually configurable to match your exact requirements
-
Technical Features
Design
Axial pump submersible without cooling system for continuous duty in pipe chambers in the stationary wet well installation.
Application
Pumping of
- Pre-cleaned sewage without faeces and long-fibre components
- Process water
- Wastewater
- Process water
Equipment/function
- Heavy-duty version made of grey cast iron
Technical Data
- Mains connection: 3~400 V, 50 Hz
- Submerged operating mode: S1
- Protection class: IP68
- Max. fluid temperature: 3 – 40°C; higher temperatures on request
- Free ball passage: 85 – 130 mm.
- Permanently lubricated roller bearings
- Max. immersion depth: 20 m
Materials
- Housing components: EN-GJL
- Propellers: Stainless steel
- Sealing on pump side: SiC/SiC
- Sealing on motor side: SiC/SiC
- Static gaskets: NBR
- Shaft: Stainless steel 1.4021
Construction
Axial submersible pump as submersible monobloc unit for stationary wet installation
Hydraulics
The angle of the propeller/impeller blades can be adjusted by hand. This makes it possible to adapt the unit to use in different conditions.
Motor
Surface-cooled motors (T motors) give off their heat directly to the surrounding fluid via the housing components and can be used in immersed state for continuous duty.
A sealing chamber protects the motor from fluid ingress. It can be accessed from the outside and can be monitored with an optionally sealing chamber electrode.
All filling fluids used are potentially biodegradable and environmentally safe.
The cable inlet of the T motors is longitudinally watertight. Cable lengths can be individually configured.
Seal
Fluid-side and motor-side sealing is possible in the following versions depending on the motor type:
- Version G: Two independently-acting mechanical seals
- Version K: Block seal cartridge with two independently acting mechanical seals
Accessories
- Switchgear, relays and plugs
Options
- Special voltages
- PTC thermistor sensor
- Internal or external sealing chamber monitoring
- Monitoring units for leakage and bearing temperature
- Ceram coating C0, C1
- Ex-rated according to ATEX or FM
-
Downloads
Click Below to Download:
Wilo-EMU KPR
Wilo-EMU KPR Certification Booklet
Group Statement REACH
UKCA 2223565
